Google says there open but no one picked up the phone and when I stopped by no one was there. Looks like there closing or allready closed

My experience was far from good, I a bare block from them for $500 had them finish hone to match my pistons, which require you to measure each piston and hone each cylinder to that piston.. I also paid them to install cam bearing as well, and I was told it would ready in a week! 3 weeks later I pick up my block and pistons, and after inspection I find the cam bearing where installed wrong, I then measure my piston and find one had expanded out of specs.... the machine shop did not tell of this problem. and just honed the cylinder to 4.030.. in all I spent $750 with them, and I need to install new cam bearing, and I may have to now have to bore this block to 4.040 if I can not find piston to the block clearences.. the build will cost me two to three times as much...

I brought a crank to them and gave them a specific number to cut it too. They hit the number dead on! Great guys to work with.

Gary is a great guy to work with.